Wiring is a method of connecting wires and electrical devices such as switchboards, fuses, sockets, light fittings, distribution boards, and so on. It transfers electrical energy from the mains supply to households, offices, factories, etc.
Wiring is fundamental since it feeds power to all the components in your house, and doing it wrong can be extremely hazardous to your safety. With time, certain appliances fade, and parts can get damaged, which can only be secured by the right electrician’s right wiring.
Some of the best electricians can create magic by the right kind of wiring tricks for residential and commercial needs. Even though the techniques have evolved after much trial and error, thinking outside the box helped them achieve mastery.
Some age-old wiring techniques are discussed below, some of which were shared by electricians in Ramsgate as well :
- Using silicon to keep wires dry: silicon caulk is non-conductive (does not allow electricity to pass and works as an excellent insulator for electrical wires. The method is more useful in places of excess moisture, such as underground or other damp locations.
- Use a paper at the slot at the screw: Take a small piece of paper and put it around the screwdriver’s tip. Use it to insert the screw inside the drilled spot tightly—the best way to do this when the slot of the screw is deep.
- It uses a new light bulb to restore a damaged one: clean the socket’s parts with the remaining debris from the old light bulb by using the new one. This can be done by rotating the new light bulb inside the socket in reverse. The dirt-free location will help the new light bulb to last longer.
- Use baby powder or cornflower to avoid itching: if you need to work in an attic or a ceiling, the chances are that you might face itchiness. In that case, applying baby powder or cornflour on your body before working can help you with the insulation.
- A handy dandy tool for cleaning: Keeping a wide paintbrush with you or carrying it in your toolbox can come in helpful to clean out any excess dust or debris around the area of your work!
- Making large holes: Instead of using a drill for making a large hole, draw out several small holes along the exterior line of the hole, and then use a ½” rigid and a hammer to make your larger hole.